Easy and Safe Gas Furnace Repairs That You Can Do As Part Of Heating System Services in Frisco TX

A lot of people consider the furnace as one of their home’s most important equipment, which is very much true most especially during cold winter months, when getting some heat intake is very important. Additionally, this is the very reason why knowing how to fix your furnace in case some troubleshooting problems arise can be very invaluable. Here are some things you can do by yourself as part of heating system services in Frisco TX.

Heating System Services in Frisco TXOn And Off Problems
If your furnace keeps on turning on and off, this is usually just a simple problem with the unit’s heat anticipator. When you open the box, you will see inside a small disk that is located in the middle.
Take a closer look and you will find the word “LONGER” on it. Then, try to find a small handle that touches aware. Once you locate that small handle, turn it towards the word “LONGER”.
After completing the steps, turn on your furnace and let it run for a few hours. Then you’re done if it works alright. If the furnace is still turning on and off, just repeat the steps given above. Continue doing so until the problem stops.

No Heat Generation
If your unit is not generating heat, then the problem is most probably the pilot light. Try to checking out your pilot light and see if it is turned on or if it is out. If you found it to be out, then you would have to relight it. In case you do not know how to relight it, simply consult your unit’ manual or contact a professional that does heating system services in Frisco TX. This is relatively easy task that you can do by simply following some simple instructions.

No Air
If your unit is running but doesn’t blow any air, turn off the power of your unit. You should turn off the gas from the gas valve which is serving your furnace. Then, remove the door of your furnace cabinet so you can have access to your blower. When you already have full access, check out the number that is stamped on the belt of your furnace. Go to your local shop and get an exact replacement of the belt. Once you’ve got the replacement belt, then go back to your furnace cabinet and install the new belt. Generally, you can just slip it on your motor’s smaller pulley then put it on your motor’s blower pulley.

Try rotating the blower pulley using your hand, while you hold the belt in place. You should be able to get the belt right in place if you get this right. You may need to adjust the motor mount so there can be more slack in the fixture if it looks a little too tight. After adjusting, try to tighten the tension again, once you have the belting the right place. It would be better to check your manufacturer’s specifications regarding the proper tension needed for your unit. Generally, your belt should deflect at least about an inch whenever you press it down.

Repairing your heating system by yourself takes time, money, and effort to get it done. If you don’t have what it takes to do the job, consider hiring professional companies that fix heating system services in Frisco TX instead. With the best people, you won’t have to worry about anything anymore.

Leave A Comment...

*